Page 1 of 1
1. (30%) A single C15X33.9 fastened to a -in. gusset plate. Use A36 steel and assume holes are for %-in. diameter bolts.
Posted: Sat May 21, 2022 2:07 pm
by answerhappygod
- 1 30 A Single C15x33 9 Fastened To A In Gusset Plate Use A36 Steel And Assume Holes Are For In Diameter Bolts 1 (101.31 KiB) Viewed 21 times
1. (30%) A single C15X33.9 fastened to a -in. gusset plate. Use A36 steel and assume holes are for %-in. diameter bolts. Base answer on tension strength of the channel and include shear rupture strength. Gusset Plate C 15X33.9 & 3@3" =9" 1-1/2" 3"3" Compute U factor? b) Compute design strengths? c) Compute block shear strength? d) Determine the maximum allowance tensile load (20% dead load and 80% live load) e) What happens to maximum allowance tensile load (increases or decreases, why?) if C10x25 is used and attached to 5/8-in. gusset plate. Assume the 12 bolts are in 3 lines parallel to the direction of loading, with the same 3-in. spacing?