Answer Happy

Accurate answers. Every time.
https://answerhappy.com/

if a sheet metal of 2 mm of thickess is to be cut using punch/die system, what would be an acceptable clearence value?

https://answerhappy.com/viewtopic.php?t=231713

Page 1 of 1

if a sheet metal of 2 mm of thickess is to be cut using punch/die system, what would be an acceptable clearence value?

Posted: Sat May 21, 2022 10:36 am
by answerhappygod
if a sheet metal of 2 mm of thickess is to be cut using
punch/die system, what would be an acceptable clearence value?
All times are UTC-05:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited