Please dont copy from other answers. It is not same question. Draw circuit on FluidSim and explain. ➢ screenshots of you
Posted: Sat May 21, 2022 10:14 am
Please dont copy from other answers. It is not same
question.
Draw circuit on FluidSim and explain.
➢ screenshots of your circuit,
➢ one paragraph explanation of your circuit,
Design and draw an electro-pneumatic circuit with 2 cylinders by FluidSim® program for the following operation steps: (1) As the initial positions, the Cylinder A is fully extended and the Cylinder B is fully retracted. (2) Start the system by pressing the main (detent) switch (turning on). (3) Wait for 1 seconds. (4) When the Cylinder B starts to extend, the Cylinder A starts to retract. (5) The Cylinder B performs the extending-retracting cycle 3 times (including the extending of B at Step 4). (6) As soon as the Cylinder B finishes retracting in the Step 5, the Cylinder A is extended. (7) Go to the Step (3) and repeat the operation. The cycle (steps 3 through 6) continues. When you want to stop the operation, press the main switch to turn off. The Cylinder Control Valves: Both control valves are n/3 (n ways / 3 positions) with spring-returned at both sides (to get the middle position as default, in which all ports are blocked). You should determinen related to: The Cylinder Types (according to the last digit of your school number) are:
Cylinder A: Double Acting. Cylinder B: Single Acting with spring-returned, extending by spring.
question.
Draw circuit on FluidSim and explain.
- Please Dont Copy From Other Answers It Is Not Same Question Draw Circuit On Fluidsim And Explain Screenshots Of You 1 (74.16 KiB) Viewed 16 times
➢ one paragraph explanation of your circuit,
Design and draw an electro-pneumatic circuit with 2 cylinders by FluidSim® program for the following operation steps: (1) As the initial positions, the Cylinder A is fully extended and the Cylinder B is fully retracted. (2) Start the system by pressing the main (detent) switch (turning on). (3) Wait for 1 seconds. (4) When the Cylinder B starts to extend, the Cylinder A starts to retract. (5) The Cylinder B performs the extending-retracting cycle 3 times (including the extending of B at Step 4). (6) As soon as the Cylinder B finishes retracting in the Step 5, the Cylinder A is extended. (7) Go to the Step (3) and repeat the operation. The cycle (steps 3 through 6) continues. When you want to stop the operation, press the main switch to turn off. The Cylinder Control Valves: Both control valves are n/3 (n ways / 3 positions) with spring-returned at both sides (to get the middle position as default, in which all ports are blocked). You should determinen related to: The Cylinder Types (according to the last digit of your school number) are:
Cylinder A: Double Acting. Cylinder B: Single Acting with spring-returned, extending by spring.