Page 1 of 1
TASK 3. Based on the initial data presented in the table, determine the limit dimensions of the hole and shaft; missing
Posted: Sat May 21, 2022 9:00 am
by answerhappygod
- Task 3 Based On The Initial Data Presented In The Table Determine The Limit Dimensions Of The Hole And Shaft Missing 1 (46.22 KiB) Viewed 13 times
TASK 3. Based on the initial data presented in the table, determine the limit dimensions of the hole and shaft; missing limit deviations of the hole and shaft; nature and characteristics of the fit; write down the numerical designation of the fit, tolerance fields of the hole and shaft. Nominal size, ei | Smax TD TU ES E es Variant Smin N. max N min mm um um 2 um um 15 , 15 um -9 um 2 , um , um um 3 30 338