Page 1 of 1
TASK 2. Based on the initial data presented in the table, determine the tolerances limit deviations of the hole and shaf
Posted: Sat May 21, 2022 9:00 am
by answerhappygod
- Task 2 Based On The Initial Data Presented In The Table Determine The Tolerances Limit Deviations Of The Hole And Shaf 1 (46.95 KiB) Viewed 13 times
TASK 2. Based on the initial data presented in the table, determine the tolerances limit deviations of the hole and shaft; the largest, smallest, probability gaps (tensions) and compare them with each other; give a graphical image of the landing; write down the numerical designation of the landing, the fields of tolerance of the hole and shaft Variant dmax mm Nominal size, mm 189 Dmax, mm 189,076 Dmin , mm 189,03 dmin, mm 188,97 30 189