Page 1 of 1
TASK 1. According to the initial data presented in the table, determine the limit dimensions of the hole and shaft; the
Posted: Sat May 21, 2022 9:00 am
by answerhappygod
- Task 1 According To The Initial Data Presented In The Table Determine The Limit Dimensions Of The Hole And Shaft The 1 (46.14 KiB) Viewed 13 times
TASK 1. According to the initial data presented in the table, determine the limit dimensions of the hole and shaft; the largest, smallest, probability gaps (tensions) and compare them with each other; calculate the landing tolerance; give a graphical image of the landing; write down the numerical designation of the landing, the fields of tolerance of the hole and shaft. ES, um EJ, um Variant 30 Nominal size, mm 89 ei , um es, um -40 +28 +10 -55