Page 1 of 1
TASK 4. According to the initial data presented in the table, determine the limit dimensions of the hole and shaft; the
Posted: Sat May 21, 2022 9:00 am
by answerhappygod
- Task 4 According To The Initial Data Presented In The Table Determine The Limit Dimensions Of The Hole And Shaft The 1 (42.17 KiB) Viewed 15 times
TASK 4. According to the initial data presented in the table, determine the limit dimensions of the hole and shaft; the largest, smallest, probability gaps (tensions) and compare them with each other; calculate the landing tolerance; give a graphical image of the landing; write down the numerical designation of the landing, the fields of tolerance of the hole and shaft. Variant 29 Nominal size, mm 14 Fit H10/f9