Page 1 of 1
TASK 1. According to the initial data presented in the table, determine the limit dimensions of the hole and shaft; the
Posted: Sat May 21, 2022 8:59 am
by answerhappygod
- Task 1 According To The Initial Data Presented In The Table Determine The Limit Dimensions Of The Hole And Shaft The 1 (45.55 KiB) Viewed 17 times
TASK 1. According to the initial data presented in the table, determine the limit dimensions of the hole and shaft; the largest, smallest, probability gaps (tensions) and compare them with each other; calculate the landing tolerance; give a graphical image of the landing; write down the numerical designation of the landing, the fields of tolerance of the hole and shaft. Nominal size, mm 14 ES, um Variant 29 EJ, um es, um -32 ei , um -50 +50 +13