Questions 33 to 34 [4] Given: R1, R2, R3, R4, Vpp, Offset, f and t/div Overview: In this question you will build and tes

[answerhappygod]

Questions 33 To 34 4 Given R1 R2 R3 R4 Vpp Offset F And T Div Overview In This Question You Will Build And Tes 1 (106.45 KiB) Viewed 9 times

Questions 33 to 34 [4] Given: R1, R2, R3, R4, Vpp, Offset, f and t/div Overview: In this question you will build and test a circuit with an AC input using TinkerCAD Circuits. Instructions: Figure 7: R1 M R2 Vin R4 V R3 1. Build the circuit in Figure 7 in TinkerCAD Circuits. 2. Use the function generator to generate a sine wave with frequency f, peak-to-peak voltage Vpp, and offset voltage given by Offset. Vin is the signal that will be generated by the function generator after setting it up with the given parameters. Please Note: Peak-to-peak voltage is the voltage difference between the maximum and mini- mum voltage of a signal. 3. Connect the oscilloscope across the resistor R3 to measure Vo as indicated in Figure 7. Set the time per division t/div setting of the oscilloscope 4. Run the simulation and wait until the measured signal on the oscilloscope has stabilised. Observe and measure the voltage V, as displayed on the oscilloscope. Please Note: Frequency is the inverse of the period. What is the peak-to-peak voltage V, across Rg? 33 Vopp [2] What is the frequency of the voltage Vo across R3? 34 f 2]