Answer Happy

Lab 5: Standard Numbered ACL Requirements 
Create a standard numbered ACL which performs the following functions:
o
Block all traffic from the 20.0.1.0/24 network to all the 10.0.0.0 subnets displayed in the
figure o
Block all traffic from host 20.0.2.100 to all of the 10.0.0.0 subnets displayed in the figure
o
Block all traffic from host 20.0.3.100 to all of the 10.0.0.0 subnets displayed in the figure
o Permit all other traffic 
You choose the device on which to enable the ACL, the interface, and the direction

You may enable the ACL in one place only, in one direction only

As seen in the initial configurations:
o
Assume all router interfaces shown in the lab are up, working and have correct IP
addresses assigned o
Assume routing between all devices is configured and operational
o
Assume that at least one host exists on each VLAN with an IP address ending in .100 with
correct gateways configured.