Page 1 of 1

Fill in the blanks and show how you got them, thank you and have a great day!

Posted: Wed May 18, 2022 7:43 am
by answerhappygod
Fill in the blanks and show how you got them, thank you and have
a great day!
Fill In The Blanks And Show How You Got Them Thank You And Have A Great Day 1
Fill In The Blanks And Show How You Got Them Thank You And Have A Great Day 1 (65.1 KiB) Viewed 63 times
TABLE I - MASS AND DIMENSIONS 1st Mass Measurement 2nd Mass Measurement Volume (cm) Density (g/cm) 1st 2nd Dimensions Dimensions Measurement Measurement rule (mm) caliper (mm) (least precise) (most precise) L: 26 L: 25.69 Cube 1 74.5 74.443 W: 26 W: 25.64 H: 26 H: 25.57 L: 25 L: 25.64 Cube 2 147.4 147.778 W: 26 W: 25.61 H: 26 H: 25.67

TABLE II -- DIAMETER MEASUREMENTS Trial # Measured Diameter (mm) 1 12.61 2 12.64 3 12.62 4 12.59 5 12.63 6 12.61 7 12.60 8 12.64 9 12.59 10 12.62 Mean: Standard Deviation:

TABLE III MASS, VOLUME, and DENSITY Calculated Volume (cm) Calculated Density (g/cmº) Cylinder 1 Measured Length Measured Mass & Diameter (mm) L: 50.13 53.641 D: 12.70 Cylinder 2 L: 50.17 56.424 D: 12.68 Cylinder 3 L: 50.11 49.315 D: 12.69

TABLE IV – Time and Velocity Length:_ 1.000 (m) Measured time Trials Clock (s) Stop Watch (s) Photogate (s) Range Finder (s) 1 1 1.33 1.3769 1.4000 2 1 1.42 1.4542 1.3500 3 2 1.44 1.4867 1.3500 4 1 1.34 1.3700 1.3500 5 2 1.47 1.3357 1.5000 Mean of time Standard Deviation of time Velocity (m/s)