Answer Happy

Accurate answers. Every time.
https://answerhappy.com/

Edged impressions spotted in this casting is quite likely due to MER Gate design Casting shrinkage Low filling rate of t

https://answerhappy.com/viewtopic.php?t=187468

Page 1 of 1

Edged impressions spotted in this casting is quite likely due to MER Gate design Casting shrinkage Low filling rate of t

Posted: Mon May 16, 2022 7:05 am
by answerhappygod
Edged Impressions Spotted In This Casting Is Quite Likely Due To Mer Gate Design Casting Shrinkage Low Filling Rate Of T 1
Edged Impressions Spotted In This Casting Is Quite Likely Due To Mer Gate Design Casting Shrinkage Low Filling Rate Of T 1 (129.19 KiB) Viewed 36 times
Edged impressions spotted in this casting is quite likely due to MER Gate design Casting shrinkage Low filling rate of the molten metal Premature movement of mold after casting
All times are UTC-05:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited