Page 1 of 1
Which of the following is least valid when pulling a wire through a die to reduce its cross section? The pulling force i
Posted: Mon May 16, 2022 7:05 am
by answerhappygod
- Which Of The Following Is Least Valid When Pulling A Wire Through A Die To Reduce Its Cross Section The Pulling Force I 1 (23.32 KiB) Viewed 34 times
Which of the following is least valid when pulling a wire through a die to reduce its cross section? The pulling force is limited by the yield strength of the wire. Use of lubrication can reduce the drawing force. The die design influences the amount of redundant work done on the wire. Surface finish of the drawn wire is worsened due to work hardening.