Answer Happy

172 HEX PO ACR FLT M20 5.60 ex 011 020 300 12 EOL SPONG 03- rto YO x 20 30 MO M350 0150 PTI CAP MATLI 4 REOD 3 X 012 M16x1.5-69 PO RAISED DIAMOND KNURL- 4X 016- M2225-69 15.954 015 ses (1677) - -450 0.61 1 1 E 4 45° X 2 M6x1-4g6gx16 LG 036 20 A 2520- 45" X 2 BOTH SIDES 110 PT 2 MATL - MS CONNECTOR 6 REQD ROUNDS AND FILLETS R4 EXCEPT WHERE OTHERWISE SHOWN 1 REVISIONS 27/06/04 RHINES 25 IN PT 2 WAS 20
Unt 16 173 MIO 1.5.00 020 26 -M6x1.60 PTS NUT MATLORAD 12 REGD BOTH SIDES 020 IK DS PO STRAIGHT NURL NOTE: UNLESS OTHERWISE SHOWN -TOLERANGES ON DIMENSIONS 105 -TOLERANCES ON ANGLES 150 BURFACES TO BE » QUESTIONS: 1 Calculate dimensions A to K Refer to Part 1 2. How many holes are in the part? 3 How many external threads are on the part? 4. How many internal threads are in the party 6. What is the pitch for the M20 thread 6. How many complete threads are in the M20 hole? 7. How many complete threads are on the M42 section? 8. What is the diameter of the spotlace? 9. What is the angle between the 11 holes ? 10. How much extra metal was provided on the surface that required machining? THREAD CONTROLLING ORGANIZATION AND STANDARD - ASME BS 13M-2001 Refer to Part 2 11. What is the pitch of the internal thread? 12. What is the pitch on the M22 thread? 13 What provides for better gripping when rotating the part? 14. How many undercuts are shown? 15. How many chamters are required? 16. If the standard fit of 1617 was changed to 1896, what would be the new limite for the size of the shaft? Refer to Part 3 17. How many holes are in the part? 18. What is the depth of the counterbore? 19. How many full threads has the M16 hole? 20. What surface finish is required for the sides of the knurled portion? 21. What are the tap drill sizes required for the A) MG and. (B) M16 threaded holes? METRIC DIMENSIONS ARE IN MILLIMETERS A DRIVE SUPPORT DETAILS A-52M