Answer Happy

A sprocket with diameter of 6 inch and number of teeth of 17 rotates 400 RPM clockwise, and transmits 35 hp to another sprocket with diameter of 10 inch and number of teeth of 70. Assume the service and design factors are of values of 1. The chain is assumed with four strand. What is the minimum chain ANSI number? A sprocket with diameter of 6 inch and number of teeth of 17 rotates 400 RPM clockwise, and transmits 35 hp to another sprocket with diameter of 10 inch and number of teeth of 70. Assume the service and design factors are of values of 1. The chain is assumed with four strand. What is the lubrication type associated with the minimum chain ANSI number? An elevator is assembled to raise equipment to a height of 866 inches. It is estimated that maximum weight of the equipment to be raised is 1100 lbf. It is observed acceleration in such cases is 47 inch/s2. 0.4 inch diameter wire ropes of type 6x37 with core are used. Number of wire ropes can be taken 2. Calculate Ft in Ibf An elevator is assembled to raise equipment to a height of 866 inches. It is estimated that maximum weight of the equipment to be raised is 1100 lbf. It is observed acceleration in such cases is 47 inch/s. 0,4 inch diameter wire ropes of type 6x37 with core are used, Number of wire ropes can be taken 2. Calculate the diameter of the wire and the area of metal, in order (diameter of the wire, the area of metal).
A pulley with diameter of 6 inch rotates 2000 RPM clockwise, and transmits 20 hp to another pulley with diameter of 10 inch, using C162 V-belt type W belt. Assume the service and design factors are of values of 1. What are the correction factors K1 and K2 assuming C=40? A pulley with diameter of 10.926 inch rotates 2000 RPM clockwise, and transmits 20 hp to another pulley with diameter of 21.044 inch, using C120 V-belt type W belt. Assume the service and design factors are of values of 1. What is the distance from center of pulley 1 to center of pulley 2 in inches assuming Lp=124.837 inches? A pulley with diameter of 10 inch rotates 1,192 RPM clockwise, and transmits 32 hp to another pulley with diameter of 28 inch, using C130 V-belt type W belt. Assume the service and design factors are of values of 1. What is the value of F1 in lbfif Nb=3, (phi) is 2.691 rad and Fe=2.475 ibf. A pulley with diameter of 17.349 inch rotates 604.481 RPM clockwise, and transmits 47.614 hp to another pulley with diameter of 20 inch, using C120 V-belt type W belt. Assume the service and design factors are of values of 1. Tabulated power for the belt is in HP is equal to _? Do interpolation! Driving and driven sprockets are rotating at 500 rpm and 300 rpm, respectively. If number of teeth on driving sprocket are 17 nd number of teeth in the driven sprocket. The driving sprocket has 30 teeth and rotates at 400 rpm. The pitch of the chain is 1.75 inch. Calculate the velocity of the chain in feet per minute. allowable belt load is 500 Calculate the minimum number of belts required to transmit this load (assume any correction factor has a value of 1). A leather at belt with a width of 10 inch and t = 13/64 transmit 20 hp between two pulleys 100 inches apart The small pulley has a diameter of 10 inch and rotate at 1500 RPM. What is the centrifugal force in lbf