Page 1 of 1
A flat plate with sharp leading edge is placed in the test section of a low-speed wind tunnel. The working section of th
Posted: Mon May 16, 2022 6:02 am
by answerhappygod
- A Flat Plate With Sharp Leading Edge Is Placed In The Test Section Of A Low Speed Wind Tunnel The Working Section Of Th 1 (352.12 KiB) Viewed 64 times
A flat plate with sharp leading edge is placed in the test section of a low-speed wind tunnel. The working section of the wind tunnel has been designed to produce a region of constant free stream velocity (i.e., for x S 1.0 m, U = 27.0 m/s), followed by a region of decelerating flow (i.e., for x 2 1.0, U. = A (1 - 5m/s, Figure Q1. bres Wind Tunnel Wall m Ue = 27.0 for x S 10 m = m, Ue = 4(1-. m/s. ++++ for x 2 1.0 m For T3 1.0 m Flat Plate Figure Q1 U is the freestream air velocity, x is the streamwise position in meter, Lref is a reference length equal to 10 m and x = 0 corresponds to the leading edge of the flat plate. 1- Determine the constant A and its dimension.