Page 1 of 1
A cyindrical tube is to be fabricated using secolithography, The outside diameter of the cylinder is 75 mm and the corre
Posted: Sun May 15, 2022 10:36 pm
by answerhappygod
- A Cyindrical Tube Is To Be Fabricated Using Secolithography The Outside Diameter Of The Cylinder Is 75 Mm And The Corre 1 (9.03 KiB) Viewed 44 times
A cyindrical tube is to be fabricated using secolithography, The outside diameter of the cylinder is 75 mm and the corresponding inside diameter is 28 mm. The length of the lube (z-direction) is 57 mm. Layer thickness 0.16 mm, and the width of the extrudate deposited on the surface of the part 021 mm. The exuder work and moves in the xy plane at a speed of 597 Adelay of 73 seconds is experienced between each layer to reposition the workable Assume a setup time of 16 minutes Estimate the total cycle time to make this part Give your estimate in terms of hoor