Answer Happy

Please answer and provide the work and explanation for each
question. Thank You!
I - An input signal consists of three frequency components at 100 Hz, 1000 Hz, and (25pts) 10 KHz. Each input component has an amplitude of 5 (V). This input signal is to be passed through a first order las pals filter. It is required to reduce the GMA 1000 HZ component by a factor of 198 A 50 CV/V] high pass a) Determine the cutoff (or half-power) frequency required. filter b) Design an RC circuit with the required cutoff frequency. You must use a 5 k2 resistor, and draw a schematic diagram. OkHz c) What will be the voltage amplitudes of the 100 Hz and 1000 Hz components of the output signal? H Draw schematic here: C 9 a) for 4 b) Fill in your calculated capacitor value: C=. c), Output amplitude of 100 Hz component dekat Output amplitude of 1000 Hz component: S 5 ماه (V [V]