Page 1 of 1
2 7. Program control will switch to when this instruction is executed. JSR JUMP-TO-SUBROUTINE SBR file number U:3 a. Lab
Posted: Sun May 15, 2022 7:34 pm
by answerhappygod
- 2 7 Program Control Will Switch To When This Instruction Is Executed Jsr Jump To Subroutine Sbr File Number U 3 A Lab 1 (55.14 KiB) Viewed 50 times
2 7. Program control will switch to when this instruction is executed. JSR JUMP-TO-SUBROUTINE SBR file number U:3 a. Label 3 b. File 3 c. Rung 3 d. 3 rungs after this rung 8. Which of these instructions is not a data compare instruction? a. LESS THAN b. EQUAL TO c. GET / PUT d. GREATER THAN 9. The MOVE instruction a. copies data from a source word to a destination word b. copies data from a destination word to a source word c. converts an integer word to a floating-point word d. converts a floating-point word to an integer word 10. For most PLC installations, a NEMA enclosure is recommended. A. 2 B. 4 C. 8 D. 12 11. Proper grounding procedures for a PLC installation specify that: A. all enclosures, CPU and I/O chassis, and power supplies be connected to a single low-impedance ground. B. paint or nonconductive materials should be scraped away to provide good ground connections. C. all ground connections should be made using star washers. D. all of these