- Mips Control Signals For This Problem Refer To The Datapath Shown On The Previous Page Which Is Figure 4 17 From The Bo 1 (242.29 KiB) Viewed 42 times
MIPS Control Signals For this problem, refer to the datapath shown on the previous page which is Figure 4.17 from the book. For each of the following instructions, determine the appropriate value of the control signals listed in the table. Each cell should contain a 0, 1, or X. Use X if the control signal is unused or don't care". or $t0,$s1, $s4 RegDst Branch MemRead MemtoReg Mem Write ALUSre Reg Write lw $t0, 0x30($12) RegDst Branch MemRead MemtoReg Mem Write ALUSC Reg Write bne $s2, $s4, 0x0C RegDst Branch MemRead MemtoReg Mem Write ALUSre RegWrite addi $s3, $t0, 14 RegDst Branch MemRead MemtoReg Mem Write ALUSre RegWrite ori $t0,$s3, $s4 RegDst Branch MemRead MemtoReg Mem Write ALUSrc Reg Write beq $t0,$s4, $s4 RegDst Branch MemRead MemtoReg Mem Write ALUSre Reg Write andi $t0,$s1, $s4, RegDst Branch MemRead MemtoReg Mem Write ALUSrc RegWrite swl $t0,$s4, $s2, RegDst Branch MemRead MemtoReg Mem Write ALUSTO Reg Write tge $t0,$s2, $s2, RegDst Branch MemRead MemtoReg Mem Write ALUSrc Reg Write