Answer Happy

Problem Description: A conveyor for a bottling process need to be started with a NO push release button. The conveyor can then be stopped again with a NC push release button. For safety reasons the system needs to be latched in a reset dominant manner. Two batches of bottles need to be conveyed from one point to the another in the factory. For every two batches transported the conveyor was started for 2 operations and an alarm Indicator should come on for 3 seconds to notify floor workers that the conveying process of two batches is complete. The automatic registering of the conveyor actions then need to be cleared with an additional push release button. Question: Design the following PLC program on CFC and create a Visualization component for the PLC VO in CodeSys Software. Log-In, Compile. Run and Test (remember to place CodeSys in simulation mode) NOTE: The PLC program will only be evaluated on a weil labelled CodeSys Visualization Component that is running as per the Rubric below: 121 PLC Design Rubric: Start (NO) (Tapper Configured) 121 Stop (N/C) (Toggler Configured) ( 121 Process is reset dominant 111 Conveyor starts (Blue Lamp). 13) 2 conveyor operations 131 Pulse an alarm indicator (Red Lamp) for 3 sec 121 Register clear button (Tapper Configured) TOTAL MARKS (15)