Answer Happy

-Configure devices based on the information given in the tables.
You must write code to configure interface of router.
-Configure RIP (test connectivity A and B) and later cancel
RIP
-Add a static route (test connectivity between A and B
again).
You can use any PC, switch and router from the Cisco Packet
Tracer. your topology should work correctly. So, I recommend to use
the devices shown in the labs.
Please explain step by step and take a screenshot.
-Screenshot of codes to configure the router interface.
-Screenshot of codes of RIP configuration and cancellation. (Do
not forget to add ping results.)
-Screenshot of codes of static routing configuration. (Do not
forget to add ping results.)
Switch A Switch B B Router A Router B Straight-through cable Serial cable Rollover (console) Crossover cable Router EO Interface IP Address Subnet mask Router -A 192.168.1.1 255.255.255.0 Router - B 192.168.2.1 255.255.255.0 Router Clocking So Interface IP Address Subnet mask Router - A DCE 192.168.3.1 255.255.255.0 Router - B DTE 192.168.3.2 255.255.255.0 Computer IP Address Subnet mask Default Gateway PC-A 192.168.1.2 255.255.255.0 192.168.1.1 PC - B 192.168.2.2 255.255.255.0 192.168.2.1