please use tinkercad.
Posted: Mon May 09, 2022 5:49 pm
please use tinkercad.
Part 2: Connecting bulbs in parallel 1. Create a circuit with two LED ; in parallel, as shown in the circuit diagram. 2. Compare the brightness of the bulbs in this circuit to the prior circuit with two bulbs in series. HAHA 3. Using a multimeter, get the voltage and the current passing through each of the bulbs. 4. Record the data in table 2. 5. Calculate for the resistance and the electric power consumed by each bulb/load as well as for the whole circuit. 6. Do the steps 1-5 two more times while adding an additional light bulb/load each time.
PART2: PARALLEL CIRCUIT Table 1. Load Recorded Data Computed Values No. Type V A Ω w V А Ω w CIRCUIT 1 %Error= Total: Total: CIRCUIT 2 %Errors Total: Total: CIRCUIT 3 %Error= Total: Total
- Please Use Tinkercad 1 (51.15 KiB) Viewed 25 times
- Please Use Tinkercad 2 (31.37 KiB) Viewed 25 times
PART2: PARALLEL CIRCUIT Table 1. Load Recorded Data Computed Values No. Type V A Ω w V А Ω w CIRCUIT 1 %Error= Total: Total: CIRCUIT 2 %Errors Total: Total: CIRCUIT 3 %Error= Total: Total