Given the two Feature Control Frames (FCF), the top one is for the feature, the bottom is for the feature identified as
Posted: Sun May 08, 2022 9:18 pm
Given the two Feature Control Frames (FCF), the top one is for
the feature, the bottom is for the feature identified as Datum B,
what is the total Datum Feature Shift?
Image Description: The image shows two feature control frames.
The first for a hole with a diameter symbol and a dimension of
3,000 with a tolerance of +/- .005 and a feature control frame that
consist of a position symbol followed by the diameter symbol and a
tolerance of .100 with the MMC symbol followed by datum A then B
with the MMC symbol and C. The second feature control frame is for
datum B of a position symbol by the diameter and a tolerance of
.200 with the MMC followed by datum A then B.
Please select from the following:
FCF for Hole Feature Ø 3.000 4.005 0.100@ |A|B|C FCF for Datum B 0 0.200 @ AB B
the feature, the bottom is for the feature identified as Datum B,
what is the total Datum Feature Shift?
Image Description: The image shows two feature control frames.
The first for a hole with a diameter symbol and a dimension of
3,000 with a tolerance of +/- .005 and a feature control frame that
consist of a position symbol followed by the diameter symbol and a
tolerance of .100 with the MMC symbol followed by datum A then B
with the MMC symbol and C. The second feature control frame is for
datum B of a position symbol by the diameter and a tolerance of
.200 with the MMC followed by datum A then B.
Please select from the following:
FCF for Hole Feature Ø 3.000 4.005 0.100@ |A|B|C FCF for Datum B 0 0.200 @ AB B