Page 1 of 1
Force capacity represents the machine rating or machine size in compression molding. Based on the laboratory compression
Posted: Thu May 05, 2022 6:10 pm
by answerhappygod
- Force Capacity Represents The Machine Rating Or Machine Size In Compression Molding Based On The Laboratory Compression 1 (63.46 KiB) Viewed 33 times
Force capacity represents the machine rating or machine size in compression molding. Based on the laboratory compression mold matched die set having two cavities each of 9.5 x 1.0-inch area, one 0.200 inch deep and the other 0.160 inch deep, and if 50 psi is the pressure requirement for consolidation of the S-glass/epoxy prepreg (material factor) with a depth factor for any thickness of 10 psi/in., calculate the needed molding machine capacity (force) for this job. (Show Work) Force (capacity) = Consider the laboratory compression molding machine, does this fall within its capacity? Was the daylight opening of about 24 inches for the laboratory Carver Monarch compression molding machine sufficient for our mold?