A steel end plate (S275, thickness=10 mm) is used to connect a column and a beam as shown in Fig.1. The connection for c
Posted: Thu May 05, 2022 11:34 am
A steel end plate (S275, thickness=10 mm) is used to connect a column and a beam as
shown in Fig.1. The connection for column is a group of bolts (M 20) and the connection for
beam is fillet welds. Given Q=200 kN, T=30 kN and My=12 kN-m (applied at centriod of the
bolt group), it is required to:
(1) Determine the design shear (Fv,Ed) and tensile (Ft,Ed) forces at the most critical bolt;
(2) Check if the bending strength for the plate is sufficient according to EC3;
(3) Check if the strength of welds is sufficient according to EC 3 using the simplified
method.
40 Oooo 2000 O 40 2@75=150 40 -Plate 85-40 X My Z Column Q <--10 Figure. 1. Steel end plate connection (mm). F 40 2@75-150 40 Beam
shown in Fig.1. The connection for column is a group of bolts (M 20) and the connection for
beam is fillet welds. Given Q=200 kN, T=30 kN and My=12 kN-m (applied at centriod of the
bolt group), it is required to:
(1) Determine the design shear (Fv,Ed) and tensile (Ft,Ed) forces at the most critical bolt;
(2) Check if the bending strength for the plate is sufficient according to EC3;
(3) Check if the strength of welds is sufficient according to EC 3 using the simplified
method.
40 Oooo 2000 O 40 2@75=150 40 -Plate 85-40 X My Z Column Q <--10 Figure. 1. Steel end plate connection (mm). F 40 2@75-150 40 Beam