We have a crucible with a hole drilled into its bottom side and connected directly to a casting mold. What should the pr
Posted: Wed May 04, 2022 1:13 pm
We have a crucible with a hole drilled into its bottom side and
connected directly to a casting mold. What should the proper sizing
of the hole be for 1kg of molten aluminum to freely flow as it
is being melted into the mold?
(Depending on the surface tension and viscosity of the Aluminum,
as well as gravity)
connected directly to a casting mold. What should the proper sizing
of the hole be for 1kg of molten aluminum to freely flow as it
is being melted into the mold?
(Depending on the surface tension and viscosity of the Aluminum,
as well as gravity)