Page 1 of 1
Multiple Choice 14) You need to print the part shown below. In order to avoid intense cutting and surface finishing you
Posted: Mon May 02, 2022 3:51 pm
by answerhappygod
- Multiple Choice 14 You Need To Print The Part Shown Below In Order To Avoid Intense Cutting And Surface Finishing You 1 (125.48 KiB) Viewed 25 times
Multiple Choice 14) You need to print the part shown below. In order to avoid intense cutting and surface finishing you decide to use a block support with tooth-like connections to fix it to the build plate. What could go wrong? The build plate may get destroyed The build-time is much higher The supported surface may show local overheating The part may rip off the build plate