Page 1 of 1
Multiple Choice 3) In order to improve printability, the part from Q2 was hollowed out and corners were rounded. What co
Posted: Mon May 02, 2022 3:49 pm
by answerhappygod
- Multiple Choice 3 In Order To Improve Printability The Part From Q2 Was Hollowed Out And Corners Were Rounded What Co 1 (208.14 KiB) Viewed 40 times
Multiple Choice 3) In order to improve printability, the part from Q2 was hollowed out and corners were rounded. What could be a potential problem printing and post-processing this part? (Select all that apply.) The printing cost of the part is increased. The sharp corners will overheat. The part can't be depowdered. The part needs internal support structures.