Page 1 of 1
2. Write an NC program fragment, using ONLY the codes shown below, to do just the finishing cut around the contour and t
Posted: Mon May 02, 2022 3:33 pm
by answerhappygod
- 2 Write An Nc Program Fragment Using Only The Codes Shown Below To Do Just The Finishing Cut Around The Contour And T 1 (42.08 KiB) Viewed 29 times
2. Write an NC program fragment, using ONLY the codes shown below, to do just the finishing cut around the contour and the details of the shape drawn. Assume that the thickness is 20 mm. Show the tool path. (60%) 3. Note: A= last digit of your SID number; B = second last digit of your SID number G00 - rapid travel G01 - linear move G02 - cw circular move GO3 - ccw circular move M03 - start spindle CCW M00 - stop program
170 + A 30 R5 R50+A 45+(A/2) © 25+(A/2) SECTION A-A 210 + A 0 75+(A/2 R60 +B 7.50 12.50 R60-B