Device a PLC ladder Diagram that perform automatically mixing of two different chemicals in a tank: When start button ‘s
Posted: Mon May 02, 2022 1:24 pm
Device a PLC ladder Diagram that perform automatically mixing of
two different chemicals in a tank:
When start button ‘s’ is pressed, chemical ‘A1’ enters the tank
via A1 inlet. When it fills up to 1m length of tank, inlet A1
closes. When A1 inlet is closed, the chemical ‘A2’ starts pouring
in the tank through A2 inlet. A2 inlet is closed when the chemical
reaches 2m of tank’s length. After the closing of A2 inlet, stirrer
‘S’ will be on for 50 seconds. To mix both chemicals. After
stopping stirrer, it allows the mixture to drain out from ‘A3’
outlet. A3 outlet should be stopped after 100s.
There should be an emergency stop button, when it is pressed the
whole system should be stopped.
S= Start button
X1= Sensor at 1m length of tank
X2= Sensor at 2m length of tank
X= Emergency stop button
A1= Chemical A1 inlet
A2= Chemical A2 inlet
A3= Mixture outlet
A4= Stirrer’s motor
T0=50sec timer
T1=100sec timer
two different chemicals in a tank:
When start button ‘s’ is pressed, chemical ‘A1’ enters the tank
via A1 inlet. When it fills up to 1m length of tank, inlet A1
closes. When A1 inlet is closed, the chemical ‘A2’ starts pouring
in the tank through A2 inlet. A2 inlet is closed when the chemical
reaches 2m of tank’s length. After the closing of A2 inlet, stirrer
‘S’ will be on for 50 seconds. To mix both chemicals. After
stopping stirrer, it allows the mixture to drain out from ‘A3’
outlet. A3 outlet should be stopped after 100s.
There should be an emergency stop button, when it is pressed the
whole system should be stopped.
S= Start button
X1= Sensor at 1m length of tank
X2= Sensor at 2m length of tank
X= Emergency stop button
A1= Chemical A1 inlet
A2= Chemical A2 inlet
A3= Mixture outlet
A4= Stirrer’s motor
T0=50sec timer
T1=100sec timer