You are tasked to enable LDP on many of the interfaces on the Cisco CRS-3 router, and because there are many interfaces that need to have LDP enabled, you mistakenly did not enable LDP on all the required interfaces. To prevent this issue from happening again in the future, what could you do the next time you need to enable LDP on many interfaces?
A. use the mpls ldp auto-config command under the IGP routing process
B. use the mpls ldp sync command under the IGP routing process
C. use the interface all command under the MPLS LDP process
D. use the discovery command under the MPLS LDP process
You are tasked to enable LDP on many of the interfaces on the Cisco CRS-3 router, and because there are many interfaces
-
answerhappygod
- Site Admin
- Posts: 899604
- Joined: Mon Aug 02, 2021 8:13 am
You are tasked to enable LDP on many of the interfaces on the Cisco CRS-3 router, and because there are many interfaces
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!