Refer to the exhibit. An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthernet1 interface. Which t

Post by **answerhappygod** » Fri Jul 22, 2022 7:02 pm

Refer to the exhibit. An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthernet1 interface. Which two commands must be added to the existing configuration to accomplish this task? (Choose two.)

: Refer To The Ex 1 (66.99 KiB) Viewed 60 times

A. Router(config-if)#ip address 192.168.1.1 255.255.255.0 Most Voted
B. Router(config-vrf)#address-family ipv4 Most Voted
C. Router(config-vrf)#ip address 192.168.1.1 255.255.255.0
D. Router(config-if)#address-family ipv4
E. Router(config-vrf)#address-family ipv6

This topic has 1 reply

You must be a registered member and logged in to view the replies in this topic.

Register Login

Refer to the exhibit. An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthernet1 interface. Which t

Refer to the exhibit. An engineer must assign an IP address of 192.168.1.1/24 to the GigabitEthernet1 interface. Which t

This topic has 1 reply You must be a registered member and logged in to view the replies in this topic.

This topic has 1 reply

You must be a registered member and logged in to view the replies in this topic.