Learning Goal: To analyze and design a passive, first-order high-pass filter using a series RC circuit. An instrument ne

[answerhappygod]

Learning Goal To Analyze And Design A Passive First Order High Pass Filter Using A Series Rc Circuit An Instrument Ne 1 (39.59 KiB) Viewed 26 times

Learning Goal: To analyze and design a passive, first-order high-pass filter using a series RC circuit. An instrument needs to detect periodic signals of approximately 5000 Hz. The instrument operates in an environment with a lot of periodic noise ranging from a few to several hundred hertz. A high-pass RC filter can be built using available 2.4 μF capacitors; resistors of any necessary value are also available. Part B - Designing and analyzing a series RC high-pass filter Using the available 2.4 μF capacitor, what is the value of the resistor needed to make a high-pass filter with a cutoff frequency of 2400 Hz? Express your answer to three significant figures and include appropriate units. ▸ View Available Hint(s) H μA 6 R= Submit Value C Units Submit ? ▾ Part C - Measuring the effectiveness of the series RC high-pass filter To measure the effectiveness of the design, find the magnitude of the output voltage of the series RC high-pass filter for the given frequencies. Use an input voltage of 1 V. Express your answers, separated by commas, to three significant figures in units of volts. ▸ View Available Hint(s) Vout (60 Hz). Vout (2400 Hz). Vout (5000 Hz)| 1 ΠΑΣΦ ? V. V. V