Task 1 – Inverting Op-Amp – (12 Marks) Build the circuit, shown in Error! Reference source not found.1, using MultiSim.

[answerhappygod]

Task 1 Inverting Op Amp 12 Marks Build The Circuit Shown In Error Reference Source Not Found 1 Using Multisim 1 (159.51 KiB) Viewed 18 times

Task 1 – Inverting Op-Amp – (12 Marks) Build the circuit, shown in Error! Reference source not found.1, using MultiSim. Use a 1k2 resistor for Rin. For Rf use in sequence a 1k12, 10ks, then 100k22 (all 5% resistors). Set Vin to 5kHz, 10mVpk sinusoidal signal. For each value of RF, complete the table below. (Note: Use +/- 12v supply for op-amp, choice of VCC & VEE or split DC RI Rin 1.00K 2 Vin 6 U1A Vo 3 LM741 GND GND Figure 1 - Inverting Op-Amp Schematic Table 1 - Inverting Op-Amp Results RF Value Gain, Av, measured from oscilloscope and calculated. Vo (rms) Measured 1kΩ 10kΩ 100k_2 Task 1 - Completion of the table with calculations and evidence - 12 Marks (see marks scheme at end of document for clarification on marks breakdown) • Produce screen prints of the measurements taken to calculate the voltage gain o Highlight via the oscilloscope's curser the values being used in the calculations o Include screen prints of the circuit build with altered RF for each of the three values.