- Lap Joint Questions 0 O T The Following Questions All Use This Figure Assume A Bolt Will Be Put In Each Hole The P 1 (385.43 KiB) Viewed 23 times
- Lap Joint Questions 0 O T The Following Questions All Use This Figure Assume A Bolt Will Be Put In Each Hole The P 2 (259.49 KiB) Viewed 23 times
- Lap Joint Questions 0 O T The Following Questions All Use This Figure Assume A Bolt Will Be Put In Each Hole The P 3 (173.88 KiB) Viewed 23 times
The following questions all use this figure. Assume a bolt will be put in each hole. The plates are made of A992 high-strength, low alloy steel and are 9.00" wide by 0.375" thick. This bearing-type connection will use A325 bolts with thread in the shear plane (A325-N). Record forces in pounds (not kips). Answers starting with a 1 should use four significant figures, all other answers should use three significant figures. (However, exact answers will be accepted.)
Question 5 (1 point) 1) Listen How many fasteners will be counted for calculating the total bearing area?